Skip to content
Fleet Scanner
Hardware integration · Teltonika FMB020

Teltonika FMB020 OBD tracker, working inside Fleet Scanner

The Teltonika FMB020 is an ultra-small 2G GPS tracker that plugs straight into a car’s OBD port, the socket under the dashboard where a garage connects its tools. Teltonika made it for eco driving, so it keeps an eye on how each car is driven. You do not need an installer or any wires. Once it is in, it reports the car’s position, driving events and alerts to Fleet Scanner.

OBD plug and play2G mobile networkEco driving driver scoresBluetooth wireless sensors
Illustration of the Teltonika FMB020 GPS tracker
0wires to connect
33satellite tracking channels
45 mAhbackup battery
128 MBmemory
30 gweight
live_position
Speed 44 km/hGNSS Fix
01 · Live tracking · Every record

Your car on the live map within minutes

The FMB020 takes its power from the OBD socket, so there is nothing to switch on. Its satellite receiver listens to GPS, GLONASS, Galileo and BeiDou, and Teltonika rates it at under 3 metres of accuracy. With no mobile signal, it saves records in its 128 MB memory, which holds about 422,400 of them, and sends them later. In Fleet Scanner you see the car move live and can replay any past trip.

Position Speed Engine on/off Satellites in view
GPS fleet tracking software →
driving · accelerometerX -612Y 180Z 990
Harsh corneringScore -1 pt
02 · Eco driving · Motion sensor

Eco driving events turned into a driver score

Eco driving is the job Teltonika built the FMB020 for. It checks for harsh speeding up, harsh braking and harsh cornering, using GPS or its motion sensor. It also flags over speeding: the default limit is 90 km/h, and the event starts once the car goes 3% over it. Long idling, when the engine runs but the car stays still, gets its own event too. Fleet Scanner adds these up into a score for every driver.

Green driving254 Green driving value255 Over speeding251 Excessive idling
Driver scorecards →
security · alerts
Towing ALERT
03 · Crash, unplug and towing · Events

Alerts for a crash, a pulled plug or a tow truck

The FMB020 watches the motion sensor for a crash and can save a short trace of what happened just before and after. A plug-in tracker is easy to remove, so it also reports when it is unplugged. In its simple mode, it counts power below 5.25 V as unplugged. If the car is lifted or moved while the engine is off, you get a towing event. Fleet Scanner sends each alert to the right person straight away.

247 Crash257 Crash trace Unplug246 Towing
Real-time fleet alerts →
bluetooth · sensors
Van 7 °C
04 · Bluetooth sensors · Bluetooth 4.0

Wireless sensors and a headset over Bluetooth

With Bluetooth 4.0 built in, the FMB020 can pick up readings from small wireless sensors, such as one that checks the temperature in a van. It can also work with a barcode scanner or a hands-free headset. You can even set it up over Bluetooth, without a cable. Fleet Scanner keeps every sensor reading with the trip it belongs to.

BLE sensors Barcode scanner Hands-free headset
Fleet reports and dashboards →
geofence · zones
Zone YardLeft
05 · Zones · Scenarios

Zones set on the tracker and on the map

When a car parks, Auto Geofence draws a zone around where it stopped. If the car leaves that zone, you hear about it. Manual Geofence lets you store up to 50 zones on the tracker itself, as circles or rectangles, and it sends an event when the car crosses a border. In Fleet Scanner you can also draw your own zones, like your yard or a customer’s gate.

175 Auto geofence Manual geofence
Fleet geofencing software →
device_health · signal12.6V
Jamming None
06 · Signal and power · Scenarios

Jamming alerts, sleep modes and car battery checks

Thieves sometimes block the mobile or satellite signal. The FMB020 can spot mobile signal jamming, and on newer firmware it also rates GNSS jamming as none, warning or critical. To save the car’s battery while it is parked, it has four sleep modes. Fleet Scanner shows you each tracker’s health and warns you if one goes quiet.

Mobile jamming318 GNSS jamming Sleep mode Car battery voltage
Fleet reports and dashboards →

FMB020 specifications

Network2G (GSM) quad-band
SatellitesGPS, GLONASS, Galileo, BeiDou, SBAS and QZSS, with A-GPS; 33 tracking channels, -165 dBm
AccuracyUnder 3 m
First fixHot start under 1 s, warm under 25 s, cold under 35 s
PowerFrom the car’s OBD socket, 10 to 30 V DC (12 V nominal), overvoltage protection
Backup battery3.7 V, 45 mAh Li-Ion
ExtrasBluetooth 4.0, accelerometer, 2 status LEDs
Memory128 MB (about 422,400 records)
SIMNano-SIM
Sleep modesGPS Sleep, Online Deep Sleep, Deep Sleep and Ultra Deep Sleep
Size and weight52.6 x 29.1 x 26 mm, about 30 g
Working temperature-40 °C to +85 °C (without battery)
Fleet Scanner port11922

Specifications can differ between hardware revisions. Check the manufacturer’s datasheet for your exact unit.

How to connect the FMB020 to Fleet Scanner

  1. With the tracker unplugged and powered off, slide a data Nano-SIM into the FMB020 with the cut corner going in first. Turn off the SIM’s PIN request, or enter the PIN later in the Configurator.
  2. Connect to the tracker by Micro-USB or Bluetooth and open the Teltonika Configurator on a Windows computer. In GPRS settings, type your SIM’s APN, your Fleet Scanner server address and port 11922, then click Save to device.
  3. Plug the FMB020 into the OBD socket under the dashboard. In Fleet Scanner, add the tracker by its IMEI number and link it to the car.
  4. Drive for a few minutes in open sky. The car should show up on the Fleet Scanner live map.

Teltonika FMB020 FAQ

Can Fleet Scanner track a Teltonika FMB020?

Yes. Fleet Scanner reads the FMB020’s position, eco driving events, over speeding, idling, crash, towing, unplug and jamming alerts, plus its Bluetooth sensor readings. Point the tracker at port 11922.

Can I set up the FMB020 by SMS?

Yes. Teltonika lets you send all server settings in one setparam SMS, with two spaces before the text. For example: setparam 2001:yourAPN;2004:your.server.com;2005:11922. Parameter 2001 is the APN, 2004 is the server address and 2005 is the port.

Does the FMB020 work on 4G?

No. The FMB020 only uses 2G (GSM). Before you fit it, check that 2G still works in the places your cars go, because some countries are shutting 2G down.

Is the Teltonika FMB020 still sold?

Teltonika does not list the FMB020 on its end of life list, and its product page is still online. Ask your Teltonika seller about stock in your country.

FMB020 in the OBD port. Every driver scored.

From a single tracker to a mixed fleet across 1,000+ device models: live tracking, alerts, fuel, drivers, maintenance and reports in one self-hosted platform. See it with your own hardware.

Get a free demo

More supported GPS trackers

Parameter IDs are Teltonika AVL IDs given on Teltonika’s own FMB020 wiki pages; other data items are listed by name only. Teltonika and FMB020 are trademarks of Teltonika Telematics. Specifications from the Teltonika FMB020 product page, quick manual and wiki.

Take Control with
Fleet Tracking

Track vehicles in real time, optimize routes, and take full control of your fleet operations.

Free Demo