Skip to content
Fleet Scanner
Hardware integration · Coban 103A

Coban 103A GPS tracker, set up and tracked in Fleet Scanner

The Coban 103A GPS tracker is a wired 2G box for cars, vans and trucks. Coban lists it as the BN-103A, and many shops sell it as the TK103A or GPS103A. It comes with outside GPS and GSM antennas, a relay to stop the engine, a microphone and an SOS button. It can also run a siren and a fuel sensor. Fleet Scanner takes its reports on your own server and shows them as a live map, trip history and alerts.

2G GSM / GPRS, 4 bandsAntennas outside GPS and GSMRelay in the boxPort 10200
Coban 103A GPS tracker, a grey metal box with two antenna sockets and mounting ears
-165 dBmGPS sensitivity
10 s / 1 hdefault report, moving / parked
5phone numbers for alarm texts
20 km/hspeed limit for the delayed cut-off
300 mAhbackup battery
sms · fix
Mode ONLINEEvery 10 s
01 · Live tracking · GPRS reports

A new point every 10 seconds while it drives

Out of the box the 103A stays online all the time. It sends its place every 10 seconds when the car moves and once an hour when it stands still. You can change both times by SMS. Smart mode lets it go offline while parked and wake up when the car moves. Fleet Scanner draws each point on the map and keeps the whole route for playback.

online Always onlinesleep Smart modefix Report intervalposition One-time location
Live vehicle tracking →
sms · stop / resume
Relay CUTSpeed 12 km/h
02 · Engine cut-off · Relay output

Stop the engine now or once the car slows down

The relay comes in the box and goes on the fuel or power line. The stop command waits until the car is below 20 km/h before it cuts. The quickstop command cuts at once, at any speed. Resume brings fuel and power back. In Fleet Scanner only users you allow can send a cut-off.

stop Delayed cut-offquickstop Cut-off nowresume Restore fuel and power
Vehicle and equipment protection →
sms · arm / disarmsleepmoving
Armed YESDoor OPEN
03 · Anti-theft · Armed alarms

Door, ignition and shock alarms when the car is armed

Arm the 103A and it guards the parked car. Opening a door, turning the key or shaking the car each sets off an alarm with the position. If a siren is fitted it sounds too. Silent arming sends the alarm text without the siren. You can set the shock sensor to level 1, 2 or 3.

arm Armsilent Silent armdisarm Disarm Door alarm ACC alarm Shock alarm
Fleet alerts management software →
alarm · sos / powerSOS
SOSMain power LOST
04 · Safety alarms · Alarm reports

SOS button, cut wires and a flat backup battery

Hold the SOS button for 3 seconds to send a call for help. When someone cuts the car’s main power, the 103A warns you, and this alarm is on from the start. When the small backup battery gets low, it warns you twice, 15 minutes apart. Fleet Scanner turns each alarm into an alert on your phone with the place on the map.

SOSextpower Power cut alarmlowbattery Low battery alarm
Real-time fleet alerts →
sms · move / speed
Zone Depot 1Speed 96 km/h
05 · Zones and speed · Alarm reports

Geofences, a move alarm and a speed limit

The 103A has three ways to watch where a car goes. A geofence alarm fires when it enters or leaves a zone. The move alarm draws a circle around the parked car and fires when it leaves. The speed alarm fires above the limit you set. In Fleet Scanner you can draw as many zones as you like, each with its own rules.

Geofence in / outmove Move alarm radiusspeed Over speed limit
Fleet geofencing software →
sensor · fuel
Fuel 47 %Drop parked
06 · Fuel level · Optional fuel sensor

Fuel level and theft alarms with the add-on sensor

Coban sells a fuel sensor as an extra for the 103A. You set it up by SMS: send oilzero when the tank is empty and oilfull when it is full. After that the tracker reports fuel as a percentage. It raises an alarm when fuel use is too high on the road or when fuel drops while the car is parked. Fleet Scanner shows the fuel line on each trip.

oilzero Set empty tankoilfull Set full tank Fuel % Fuel theft alarm
Fuel monitoring software →
sms · acc / listenDIN1 Ignition ONAIN1 12.4 VDOUT1 Relay OFF
ACC ONMic ready
07 · Ignition and voice · ACC input + microphone

Know when the engine starts and hear inside the cab

Turn on ACC alerts and the 103A tells you each time the key goes on or off, with the place. Fleet Scanner uses the same ignition signal to split trips and count engine hours. The tracker also has a microphone. In listen mode, you call the tracker and hear what is going on inside the car.

ACC Ignition on / off alertslisten Listen modetracker Back to location mode
Trip planning and trip records →

103A specifications

Network2G GSM/GPRS, 850/900/1800/1900 MHz
GPSSensitivity -165 dBm, about 5 m accuracy
Time to first fixAbout 45 s cold, 35 s warm, 1 s hot
Power supply12 V to 24 V vehicle power
Backup battery3.7 V 300 mAh Li-ion, with its own on/off switch
Connections10-pin harness, SOS button, microphone jack, shock sensor port, USB, microSD slot
In the boxRelay, outside GPS and GSM antennas (2 m each), microphone, harness with SOS button
ExtrasSiren, fuel sensor, shock sensor
Size / weight83 x 54 x 26 mm, 120 g
Working temperature-20 °C to 45 °C, 5 to 95% humidity
Data linksTCP, UDP and SMS
Fleet Scanner port10200

Specifications can differ between hardware revisions. Check the manufacturer’s datasheet for your exact unit.

How to connect the 103A to Fleet Scanner

  1. Ask an installer to fit the 103A where the antennas can see the sky. Connect red and black to 12 V or 24 V power and wire ACC. Put the door wire on green or blue, depending on how your door switch works, and put the relay on the fuel or power line.
  2. Put in a 2G SIM with data, SMS and caller ID on, and the PIN code off. Power the tracker, wait one minute, then switch the backup battery on.
  3. Coban’s default password is 123456, and the manual says to change it on first use. Put your own password where 123456 is below. Send apn123456 plus your APN, and adminip123456 plus your Fleet Scanner server address and port 10200, with one space between each part. Send tcp123456 for TCP. Send check123456 to see the APN, server and signal it now uses.
  4. In Fleet Scanner, add the tracker by its IMEI (send imei123456 to get it) and link it to a vehicle. Drive a short loop, check the route and ignition, then hold SOS for 3 seconds to test the alarm.

Coban 103A FAQ

Does Fleet Scanner work with the Coban 103A?

Yes. Point the 103A to your own Fleet Scanner server on port 10200 with the adminip SMS command. Fleet Scanner then shows its position, ignition and alarms, and lets allowed users send the engine cut-off.

What are the main Coban 103A SMS commands?

Each command is the word, then the password, with no space between them. apn sets the SIM’s internet name. adminip sets the server and port. fix sets how often it reports while moving and while parked. stop, quickstop and resume control the engine. check shows the current settings, and begin goes back to factory settings.

Is the 103A the same as the TK103A?

Coban sells it as the BN-103A, and many shops and tracking platforms call it the TK103A or GPS103A. Coban still lists the BN-103A on its own site as a current car tracker.

What is the difference between the Coban 103A and 103B?

Coban’s manual covers both models. It says the remote control key fob is an option for the B model only. The siren, fuel sensor and shock sensor are extras for both.

How long does the Coban 103A battery last?

Coban gives the backup battery as 3.7 V 300 mAh and does not state hours. It is for short breaks in power. The tracker sends a low battery alarm when the battery gets near 3.55 V.

Will the 103A work on 4G?

No. Coban lists it for 2G GSM and GPRS only. Where 2G has been switched off, it cannot connect, so pick a 4G tracker instead.

103A wired in. Every car, alarm and route on your own server.

From a single tracker to a mixed fleet across 1,000+ device models: live tracking, alerts, fuel, drivers, maintenance and reports in one self-hosted platform. See it with your own hardware.

Get a free demo

More supported GPS trackers

Specifications and SMS commands from Coban’s BN-103A product page and user manual. Fuel data needs the optional fuel sensor. Coban and BN-103A are trademarks of Shenzhen Coban Electronics Co., Ltd.

Take Control with
Fleet Tracking

Track vehicles in real time, optimize routes, and take full control of your fleet operations.

Free Demo