Skip to content
Fleet Scanner
Hardware integration · Coban 311B

Coban 311B GPS tracker, working inside Fleet Scanner

The Coban 311B GPS tracker is a small wired box for motorbikes and other small vehicles. Coban calls it a simple motorcycle tracker for people who want easy fitting and only the main functions. It reports over 2G, cuts the fuel or power when you tell it to, and warns you if someone starts or shakes the bike. Fleet Scanner shows every 311B on one map, on your own server.

2G quad-band GSMGPS positioningBluetooth setup and auto armPort 10200
Coban 311B GPS tracker, a small black box with a cable and two status lights
12 to 24 Vvehicle power
180 mAhbackup battery
50 gdevice weight
5 mGPS accuracy
5phone numbers for alarms
command · fix
Moving gap 10 sGPS FIXED
01 · Live tracking · GPS

One report gap for riding and another for parking

The 311B can use two report gaps, one for when the bike moves and one for when it stands still. Out of the box it reports every 10 seconds on the move and once an hour when parked. The fix command changes this. For example, fix020s002h***n with your password on the end means every 20 seconds while riding and every 2 hours while parked, with no limit on the count. Fleet Scanner saves each point, so you can play back any ride.

fix+020s+002h+***n+password nofix+password position+password Moving / parked gap
Live vehicle tracking →
command · online / sleep12.6V
Mode smartBike parked
02 · Working mode · Tracker setting

Stay online all the time, or rest while parked

Coban gives the 311B two working modes. In real time online mode (online plus password) the tracker never drops off the network. In smart mode (sleep plus password) it goes offline while the bike stands still and wakes up when it starts to move. A call, a text or an alarm also brings it back online. In both modes it still reports at the gaps you set. On the Fleet Scanner map you can see which bikes are online and which are resting.

online+password sleep+password gprs+password SMS+password
Fleet reports and dashboards →
command · stop / quickstop
Fuel CUTSpeed < 20 km/h
03 · Fuel and power cut · Yellow wire + relay

Stop a stolen bike, safely or right away

A relay comes in the box. The 311B uses its yellow wire to drive it and break the line to the fuel pump. Send stop plus your password and the tracker waits until the bike is below 20 km/h before it cuts. Send quickstop and it cuts at once, at any speed. Send resume to give the fuel and power back. Use the slow way whenever someone may be riding.

stop+password quickstop+password resume+password 12 V or 24 V / 40 A relay
Vehicle and equipment protection →
alarm · ACC / sensorsleepmoving
Armed ONKey on
04 · Armed alarms · White ACC wire + shock sensor

Armed bike, key turned or bike shaken: you get a text

Arm the 311B with arm plus password, or silent plus password if you want no siren. It will not arm while the key is on. Once armed, turning the key sends an ACC alarm with the place. Shaking or moving the bike sends a sensor alarm, at most once every 3 minutes. You can set the shock sensor to level 1, 2 or 3, and it starts at 2. If you fit the optional siren to the orange wire, it sounds too.

arm+password silent+password disarm+password sensitivity+password 1/2/3
Fleet alerts management software →
bluetooth · Bn311
Phone awayArmed auto
05 · Phone as a key · Bluetooth

Walk away and the bike arms itself

The 311B shows up on your phone’s Bluetooth list as “Bn311”. Pair it with the tracker password. When you walk far enough away that the link drops, the tracker arms itself. When you come back and the phone links again, it disarms. Coban also says every SMS setting can be changed over Bluetooth with its app.

Bluetooth name Bn311 Auto arm Auto disarm Settings over Bluetooth
alarm · move / speed
Speed over limitMoved
06 · Moved and speed · Tracker + server

Alarms for a parked bike that leaves, or a rider going too fast

With move plus password and a radius, the 311B draws a circle around where it is now. If the bike goes past the edge, a movement alarm goes out. With speed plus password and a number, you set a top speed and get an alarm when the bike goes over it. Coban also lists geo-fence alarms set from the platform. In Fleet Scanner you draw zones on the map and pick who gets told when a bike goes in or out.

move+password radius nomove+password speed+password value nospeed+password Zone in / out
Fleet geofencing software →
alarm · extpower / lowbattery68%
Bike power cutBackup 180 mAh
07 · Power alarms · Red and black wires

Know when the wires are cut or the backup battery is low

The power cut alarm is on from the start. If a thief pulls the 311B off the bike’s power, it sends an alarm. A 180 mAh battery inside is there as a backup. When that battery gets close to 3.55 V, it sends a low battery alarm twice, 15 minutes apart. With ACC plus password it also texts you each time the key is turned on or off. In Fleet Scanner, each key on and key off marks where a trip starts and ends.

extpower+password on/off lowbattery+password on/off ACC+password noacc+password
Trip planning and trip records →

311B specifications

Network2G GSM/GPRS quad-band 850/900/1800/1900 MHz; TCP, UDP and SMS
PositioningHigh-precision GNSS receiver; -165 dBm sensitivity; 5 m accuracy
Time to first fixCold start 45 s, warm start 35 s, hot start 1 s
Power supply12 to 24 V vehicle power
Backup batteryRechargeable 3.7 V 180 mAh Li-ion
Wires5-pin harness: black (-) power, red (+) power, white ACC, yellow fuel and power cut, orange siren
In the boxHarness and relay (12 V/40 A or 24 V/40 A); siren (24 V/48 V) is optional
OtherBluetooth, USB port, SIM card slot
LightsGreen: GSM, blue: GPS
Size / weight6.0 x 3.5 x 1.8 cm, 50 g
EnvironmentWorking -20 to +45 °C, storage -40 to +85 °C, 5% to 95% humidity (no condensing)
Fleet Scanner port10200 (TCP)

Specifications can differ between hardware revisions. Check the manufacturer’s datasheet for your exact unit.

How to connect the 311B to Fleet Scanner

  1. Get a 2G SIM card with data and SMS. Turn on caller ID, turn off the PIN code and make sure call forwarding is off. Open the sealed buckle on the 311B, push the SIM in and close it again. The tracker switches on by itself.
  2. Plug the 5-pin harness in. Connect the red wire to (+) power and the black wire to (-) on a 12 to 24 V bike, and the white wire to the ignition (ACC). If you want remote cut-off, wire the yellow wire to the relay and the relay into the fuel pump line. Coban says a trained fitter should do this. Hide the tracker where GSM and GPS signals are still good, away from dust and damp.
  3. Text the tracker from your phone. Change the default password 123456 first (password123456 and a space and your new one), then add your number with admin, your password, a space and the number. Send apn with your password, a space and your SIM’s APN. Then send adminip with your password, a space, your Fleet Scanner domain or IP, a space and 10200. Set the report gaps with fix.
  4. Add the 311B in Fleet Scanner by its IMEI. Send imei plus your password if you do not have it to hand. Take the bike outside for a minute, then send check plus your password to see the GSM, GPS, APN, IP and port in use, and make sure the first point shows on the map.

Coban 311B FAQ

How do I connect a Coban 311B to Fleet Scanner?

Out of the box the 311B talks to Coban’s own BAANOOL IOT server. To move it to Fleet Scanner, text adminip, your password, a space, your server’s IP or domain, a space and 10200. Set the APN first with the apn command if the SIM needs it. After that, the tracker sends its points and alarms to your own Fleet Scanner server.

What SMS commands does the 311B use?

Each command is a word with the tracker password right after it. The Coban manual lists apn, up and adminip for the network and server, fix for the report gap, online and sleep for the working mode, stop, quickstop and resume for the fuel cut, arm, silent and disarm, and move, speed, extpower and lowbattery for alarms. check, imei, reset and begin show the status, show the IMEI, restart it and reset it to factory settings.

What is the difference between the Coban 311B and 311C?

Coban sells both with the same box, size and specs. On its product pages and in the shared manual, Coban says the SOS alarm and the remote control are only on the C model. So the 311B has no SOS button and no key fob. You arm it by text, from the app or with Bluetooth.

Is the 311B an e-bike GPS tracker, and how long does its battery last?

Coban lists the BN-311B with its electric motorcycle trackers, and its page says it is for motorbikes and for car anti-theft. It gives the power input as 12 to 24 V, so check your bike’s voltage before you fit it. The 180 mAh battery is only a backup. Coban gives no battery life in hours.

Is the Coban 311B still sold, and is it 4G?

Yes, Coban still lists the BN-311B on coban.net with no end of sale note. It works on 2G (GSM/GPRS) only, not 4G, so check that 2G still runs where your bikes go. Fleet Scanner works with 1,000+ GPS devices, so you can add 4G trackers to the same map later.

One small 311B per bike. All of them on your own map.

From a single tracker to a mixed fleet across 1,000+ device models: live tracking, alerts, fuel, drivers, maintenance and reports in one self-hosted platform. See it with your own hardware.

Get a free demo

More supported GPS trackers

SMS commands, wiring and alarm behaviour follow the Coban GPS Tracker User Manual for model 311BC, from the BN-311B download on coban.net. Specifications are from the Coban BN-311B product page. The B and C difference is from the Coban BN-311C product page and the same manual. Coban and BN-311B are trademarks of Shenzhen Coban Electronics Co., Ltd.

Take Control with
Fleet Tracking

Track vehicles in real time, optimize routes, and take full control of your fleet operations.

Free Demo