Skip to content
Fleet Scanner
Hardware integration · Coban 103B

Coban 103B GPS tracker, working inside Fleet Scanner

The Coban 103B GPS tracker is a 2G box you hide inside a car, van or truck. Coban sells it as the BN-103B, and many people still call it the TK103B. It works with a small remote control, so you can arm and disarm it like a car alarm. When it is armed, it warns you if a door opens, the key turns or the car is shaken. It can also cut the fuel or power, and it takes all its settings by SMS. Fleet Scanner runs on your own server and turns its reports into a live map, alerts and trip records.

2G GSM 850/900/1800/1900 MHzRemote arm and disarmRelay fuel and power cutPort 10200
Coban 103B GPS tracker, a grey metal box with two antenna sockets and mounting ears
10 sdefault report time while moving
12 to 24 Vcar or truck power
5phone numbers for SMS alerts
20 km/hspeed limit for the delayed cut-off
5jobs on the remote control
report · interval
Moving every 10 sParked 1 h
01 · Live tracking · Positioning strategy

One report time for driving, another for parking

Out of the box, the 103B stays online all the time. It reports every 10 seconds while the car moves and once an hour while it is parked. You can change both times by SMS. There is also a smart mode that goes offline when the car stands still and wakes up when it moves again. Fleet Scanner draws each report on the live map and keeps the route for playback.

Real time online Smart mode Moving interval Parked interval
Live vehicle tracking →
armed · door / acc / shockSOS
Door openState ARMED
02 · Armed alarms · Arming state

Door, key and shake alarms when the car is armed

Press arm on the remote and the 103B starts to guard the car. If a door opens, it sends a door alarm with the position. If someone turns the key or starts the engine, it sends an ACC alarm. If the car is moved or shaken, it sends a sensor alarm, at most once every 3 minutes. A siren, if you fit one, sounds too. Silent arming sends the same alarms with the siren kept quiet.

Door alarm ACC alarm Shock alarm Silent arming
Fleet alerts management software →
alarm · power / battery12.6V
Power cutBackup ON
03 · Power and SOS · Other alarms

Cut wires, a weak backup battery and the SOS button

These alarms work even when the car is not armed. Cutting the car power sends an alarm, and this is on from the start. When the built-in battery drops close to 3.55 V, the tracker warns you twice, 15 minutes apart. Holding the SOS button for 3 seconds sends an SOS alert. On the 103B, the remote has an SOS key as well. Fleet Scanner shows each one as an instant alert.

External power cut Low battery SOS button SOS key on remote
Real-time fleet alerts →
alarm · zone / move / speed
Zone Home lotMoved
04 · Zones and speed · Other alarms

Zone, move and speed alarms

A geofence is a zone you draw on the map. The 103B sends an alarm when it goes into or out of one. The move alarm draws a circle around where the car is parked and warns you when it leaves that circle. The speed alarm goes off above a speed you choose. In Fleet Scanner you can add as many zones as you like, each with its own alert rules.

Geofence in / out Move radius Over speed
Fleet geofencing software →
command · fuel and power
Stop WAITINGSpeed 32 km/h
05 · Remote cut-off · Relay

Stop the engine now, or wait until the car slows down

The 103B comes with a relay. A relay is a switch the tracker can open and close. Wire it into the fuel pump line and you can stop the engine from far away. The delayed stop waits until the car is below 20 km/h. The quick stop acts at once, at any speed. A resume command turns fuel and power back on. In Fleet Scanner, only approved users can send these.

Delayed stop Quick stop Resume
Vehicle and equipment protection →
sensor · fuel level
Fuel 48 %Theft none
06 · Fuel level · Optional fuel sensor

Fuel level and fuel theft alarms with an extra sensor

Add Coban’s fuel sensor to the 0 to 5 V fuel wire and the 103B can report how full the tank is. You set it up once: send one SMS when the tank is empty and another when it is full. After that, it sends a fuel alarm if fuel drops too fast while driving, or if fuel is stolen while parked. Fleet Scanner shows the level as a chart over time.

Fuel sensor 0 to 5 V Empty point Full point Fuel alarm
Fleet fuel management software →
notice · acc on / offDIN1 Ignition ONAIN1 12.4 VDOUT1 Relay OFF
ACC ONTrip started
07 · Ignition and listen-in · ACC wire and microphone

Know when the engine starts and stops, and listen in

The white wire goes to ignition (ACC). Turn on ACC alerts and the 103B tells you each time the car starts or stops, with the position. A small microphone comes in the box. In listen mode, you call the tracker and hear what is going on inside the car. Fleet Scanner uses the ignition state to split the day into trips.

ACC on ACC off Listen mode Door wire, + or -
Trip planning and trip records →

103B specifications

Network2G GSM/GPRS, 850/900/1800/1900 MHz
GPSSensitivity -165 dBm, accuracy about 5 m; first fix about 45 s cold, 35 s warm, 1 s hot
Power supply12 to 24 V DC from the vehicle
Backup batteryRechargeable 3.7 V lithium-ion, with its own on/off switch
Wires (10-pin harness)Red power, black ground, white ignition (ACC), green door (+), blue door (-), SOS button, white with black fuel sensor (0 to 5 V), orange siren, yellow relay
Remote controlArm, disarm, silent arm, SOS and car locate (B model only)
Other portsMemory card slot, microphone jack, USB, socket for an extra shock sensor
AntennasExternal GPS and GSM antennas, 2 m cables
SIM cardStandard size SIM
Size / weight83 x 54 x 26 mm, 120 g
Operating temperature-20 to 45 °C (storage -40 to 85 °C)
ProtocolTCP, UDP or SMS
Fleet Scanner port10200 (TCP)

Specifications can differ between hardware revisions. Check the manufacturer’s datasheet for your exact unit.

How to connect the 103B to Fleet Scanner

  1. Get a standard size 2G SIM with data, SMS and caller ID on, its PIN lock off and call forwarding off. Open the case with the small screwdriver from the box and slide the SIM in.
  2. Plug in the 10-pin harness. Connect red to 12 V or 24 V, black to ground and white to ignition (ACC). Wire the relay into the fuel pump line and put the SOS button where the driver can reach it. Face the GPS antenna to the sky. Wait 1 minute after power on, then flip the backup battery switch on.
  3. Send these SMS commands from your phone (123456 is the default password, so change it first with password123456 newpassword and use the new one after that): apn123456 yourAPN for the SIM’s internet settings, adminip123456 your-server 10200 for your Fleet Scanner server, tcp123456 to send over TCP and fix010s001h***n123456 to report every 10 seconds when moving and every hour when parked.
  4. Send imei123456 to get the IMEI number and add the tracker in Fleet Scanner with it. Send check123456 to see the APN, server and port it is using. Then take a short drive and check the map, the ignition state and an arm and disarm from the remote.

Coban 103B FAQ

Does Fleet Scanner support the Coban 103B (TK103B)?

Yes. Point the 103B at your Fleet Scanner server on port 10200. Fleet Scanner then shows its live position, ignition and alarms, and it can send the fuel and power cut-off. Fleet Scanner runs on your own server, with white label included.

What are the main TK103B SMS commands?

Each command is the command word, then the password, with no space in between. Some examples with the default 123456: apn123456 yourAPN sets the APN, adminip123456 IP port sets the server, admin123456 phone number adds a number for alerts, arm123456 and disarm123456 arm and disarm, and begin123456 goes back to factory settings.

How is the Coban 103B different from the 103A?

Coban uses one user manual for both. It says only the B model supports the remote control, and only the B model has the antenna for it. The rest of the manual is written for both models.

How do I stop a car remotely with the 103B?

Wire the relay first. Then send stop123456 for a delayed stop, which waits until the car is below 20 km/h. Send quickstop123456 to stop it at once, and resume123456 to let it start again.

What happens if a thief cuts the 103B’s power?

It sends an external power alarm, which is switched on from the start. Remember to turn on the backup battery switch when you fit it. When the built-in battery gets low, it sends two low battery alarms, 15 minutes apart.

Does the Coban 103B work on 4G?

No. The 103B only uses 2G GSM and GPRS on 850, 900, 1800 and 1900 MHz. If your country has shut down 2G, it will not get a signal there. Pick a 4G tracker instead; Fleet Scanner works with more than 1,000 GPS devices.

103B armed. Every car on your own live map.

From a single tracker to a mixed fleet across 1,000+ device models: live tracking, alerts, fuel, drivers, maintenance and reports in one self-hosted platform. See it with your own hardware.

Get a free demo

More supported GPS trackers

Alarms, SMS commands and wiring follow Coban’s BN-103B product page and its 103A/B user manual. Fuel level needs Coban’s optional fuel sensor, and the siren is optional too. Coban and BN-103B are trademarks of Shenzhen Coban Electronics Co., Ltd.

Take Control with
Fleet Tracking

Track vehicles in real time, optimize routes, and take full control of your fleet operations.

Free Demo