Skip to content
Fleet Scanner
Hardware integration · Teltonika FMC230

Teltonika FMC230 waterproof 4G tracker for boats and heavy machines

The Teltonika FMC230 is a GPS tracker in an IP67 case, built for rain, mud, dust and salty sea air. It talks over 4G LTE Cat 1 and drops back to 2G where there is no 4G. Teltonika aims it at tractors, diggers, boats and other machines that work outside and burn a lot of fuel. Pair it with Fleet Scanner on your own server and the whole yard, field or harbour shows up together.

IP67 click-shut caseLTE Cat 1 falls back to 2G3 · 2 · 3 DIN · AIN · DOUT1-Wire + BLE keys, probes, sensors
Illustration of the Teltonika FMC230 GPS tracker
IP67short dips under water
LTE Cat 14G network
170 mAhLi-ion backup battery
10 to 30 Vpower from the vehicle
422,400records kept in 128 MB
position · LTE Cat 1
LTE Cat 1Speed 18 km/h
01 · Live tracking · Every record

A 4G GPS tracker that keeps a clean track

The FMC230 uses GPS, GLONASS, Galileo and BeiDou to find its place. A static navigation filter stops the dot from jumping around while a boat or machine stands still. Out of signal, it saves up to 422,400 records and sends them once 4G or 2G comes back. The late points slot into the trip in Fleet Scanner, so no part of the route goes missing.

Position Speed Ignition Movement Saved records
Live GPS vehicle tracking →
power · 10 to 30 V12.6V
Main power 12.6 V
02 · Power · Vehicle + battery

Wired to the battery, with a spare inside

The FMC230 runs from 10 to 30 V, so a car, truck, tractor or boat battery all work. A small 170 mAh Li-ion battery sits inside as a spare. If the main wire is cut or pulled, Fleet Scanner shows the drop in voltage and can warn you that the tracker was unplugged.

External voltage Battery voltage Unplug detection
Instant fleet alerts →
flexible_inputs · 2x6 socketDIN1 Ignition ONAIN1 12.4 VDOUT1 Relay OFF
DIN1 ONAIN1 4.2 V
03 · Flexible inputs · Wired I/O

Inputs that can be digital or analog

Teltonika calls these flexible inputs. Two of the pins can work as a digital input or as an analog input that reads 0 to 30 V. In total you get 3 digital inputs, 2 analog inputs and 3 outputs. Use them for a door switch, a fuel level sensor, a work light or a relay that blocks the engine.

Digital inputs 1 to 3 Analog inputs 1 and 2 Outputs 1 to 3
Vehicle and equipment protection →
driver_id · 1-Wire + BLEA3 41 9F 00
Operator known
04 · Drivers and sensors · 1-Wire + Bluetooth

Driver keys, probes and Bluetooth

Plug an iButton reader or a temperature probe into the 1-Wire pins. Each operator taps a key before work, so Fleet Scanner knows who used which machine and for how long. Bluetooth 4.0 LE is built in for wireless add-ons.

iButton ID Temperature probe Bluetooth 4.0 LE
Construction equipment tracking →
driving · accelerometerX -612Y 180Z 990
Sharp turn
05 · Driving events · Accelerometer

Rough driving and crash events

An accelerometer inside watches each direction of movement. With Green Driving turned on, the FMC230 reports hard braking, hard starts and sharp turns, and Over Speeding fires above the limit you choose. It can also record a crash. Each one counts against that driver in Fleet Scanner’s safety score.

Harsh braking Harsh acceleration Harsh cornering Over speeding Crash
Driver behaviour reports →
security · scenarios
Left zone
06 · Theft protection · Scenarios

Stop a boat or machine from walking away

Auto geofence draws a zone around a parked machine and reports when it leaves. Unplug detection tells you someone took the tracker off power. The immobilizer scenario keeps the starter locked until an approved key touches the reader. Fleet Scanner pushes these alarms to your phone or inbox within seconds of the report.

Auto geofence Unplug Immobilizer
Geofencing software →

FMC230 specifications

StatusCurrent at Teltonika; it is the named replacement for the FMB230
Network4G LTE Cat 1 with 2G (GSM) fallback; the bands depend on the version you order
SatellitesGPS, GLONASS, Galileo, BeiDou, QZSS, AGPS; tracking sensitivity -165 dBm
Power10 to 30 V DC with overvoltage protection
Battery170 mAh Li-ion, 3.7 V (0.63 Wh)
Inputs and outputs3 digital inputs (1 negative, 2 impulse), 2 analog inputs (0 to 30 V), 3 open collector outputs (0.5 A)
Extras1-Wire (iButton, temperature), Bluetooth 4.0 LE, LVCAN lines on inputs 5 and 6, accelerometer
Memory128 MB flash (about 422,400 records)
ProtectionIP67, click-type two-phase closing, gasket resistant to salt water; Standard or U-type cable
Size70.5 x 67.0 x 25.6 mm (85.0 mm long with the connector socket)
Fleet Scanner port11922

Specifications can differ between hardware revisions. Check the manufacturer’s datasheet for your exact unit.

How to connect the FMC230 to Fleet Scanner

  1. Pick a spot in the cabin or outside; the IP67 case allows both. Close the case by hand with its two-phase click, no tools needed. Wire power (10 to 30 V) and ground, and put the ignition on DIN1.
  2. Fit a SIM with 4G data. For FMC230 setup, open the Teltonika Configurator and type in the APN, then your Fleet Scanner host name, port 11922 and the TCP protocol.
  3. No computer? Text the tracker. With no SMS login or password set, start with two spaces: " setparam 2001:APN;2002:user;2003:pass;2004:your.server;2005:11922;2006:0". The final 2006:0 chooses TCP.
  4. In Fleet Scanner, add the FMC230 by its IMEI, link it to the machine or boat, then run it for a few minutes and watch it appear on the map.

Teltonika FMC230 FAQ

Can I use the Teltonika FMC230 with Fleet Scanner?

Yes. Point the tracker at port 11922 and Fleet Scanner takes in location, ignition state, every input and output, voltage, iButton keys, temperature and driving events. It runs on your own server and you can put your own brand on it.

What are the FMC230 SMS commands for APN and server?

Each text follows this order: SMS login, space, SMS password, space, command, space, value. The setparam command changes settings by number: 2001 APN, 2002 APN user, 2003 APN password, 2004 server address, 2005 port and 2006 protocol (0 for TCP, 1 for UDP). getinfo replies with the tracker’s status. One text can hold up to 160 characters.

How waterproof is the FMC230?

Teltonika rates it IP67. It handles hose spray and jets, and short dips of 150 mm to 1,000 mm under water for up to 30 minutes. Its gasket resists salt water, so Teltonika suggests it for fishing boats and motorboats.

Is the FMC230 still for sale?

Yes. Teltonika’s end of life list does not include the FMC230. It names the FMC230 as the replacement for the 2G FMB230, which stopped being ordered on 1 September 2025.

How is the FMC234 different from the FMC230?

Teltonika says the FMC234 is the FMC230 upgraded with a much bigger battery: 1,000 mAh in place of 170 mAh. Pick the FMC234 if the tracker must keep reporting for days with no outside power.

FMC230 sealed and wired. Every machine on your map.

From a single tracker to a mixed fleet across 1,000+ device models: live tracking, alerts, fuel, drivers, maintenance and reports in one self-hosted platform. See it with your own hardware.

Get a free demo

More supported GPS trackers

The labels come from Teltonika’s FMC230 documents and carry no AVL ID numbers, since we could not check the IDs for this exact model. FMC230 is a Teltonika Telematics trademark. Facts on this page come from Teltonika’s FMC230 product page, datasheet, wiki and use case article.

Take Control with
Fleet Tracking

Track vehicles in real time, optimize routes, and take full control of your fleet operations.

Free Demo