Skip to content
Fleet Scanner
Hardware integration · Teltonika FMC650

Teltonika FMC650 GPS tracker for trucks, connected to Fleet Scanner

The Teltonika FMC650 is a 4G tracker for trucks, buses and big machines that need many extras wired in at once. It reads the truck’s FMS data, talks to the tachograph and takes fuel sensors, card readers and Bluetooth sensors. Teltonika launched it in January 2023 to replace the FMC640, and it is on sale today. Fleet Scanner reads all of its data on your own server.

4G LTE Cat 1 with 2G backupL1 + L5 dual-band GNSSTachograph live data + DDD filesCurrent model replaces the FMC640
Illustration of the Teltonika FMC650 GPS tracker
4digital inputs
4digital outputs
4analog inputs
16 MBbuilt-in memory
32 GBmicroSD card support
tachograph · DDDA3 41 9F 00
Driver 1 drivingToday 4h 05m
01 · FMC650 tachograph · K-Line / CAN

FMC650 tachograph data, live and as files

Truck drivers must log their driving and rest hours on a tachograph. The FMC650 can read it live over the K-Line, the tacho CAN or the FMS line, so you see each driver’s state as it changes. It can also fetch the legal tachograph files (DDD) from far away through Teltonika’s TachoSync service. Fleet Scanner shows who is driving and for how long.

184 Driver 1 working state195 Driver 1 ID Remote DDD file downloadRemote file download needs firmware 03.00.14.Rev.07 or newer on new tachographs
Compliance reminders for fleets →
fms · CAN J1939
Tank 58 %RPM 1,420
02 · Truck data (FMS) · 2 x CAN

Fuel and engine numbers from the truck itself

Big trucks send their own numbers over a CAN line using the FMS standard. The FMC650 has two CAN lines plus J1708 and K-Line, and it can switch its CAN end resistors on or off from far away. It picks up the fuel tank level, the fuel burned so far and the engine speed. Fleet Scanner turns them into fuel and engine reports.

87 Fuel level (%)86 Engine total fuel used88 Engine speed (rpm)
Fuel monitoring system →
position · L1 + L5
4GGNSS L1 + L5
03 · Live tracking · Dual-band GNSS

Sharper tracks from a dual-band GNSS module

Most trackers listen to one satellite band. The FMC650 has its own GNSS chip that hears two bands, L1 and L5, from GPS, GLONASS, Galileo, BeiDou and QZSS. Teltonika says this puts the track closer to survey-grade gear and suits road toll systems. Data goes out over 4G and drops to 2G where 4G is missing.

239 Ignition Position, speed, heading Two SIMs or one eSIM
GPS fleet tracking software →
fuel · LLS
Parked drop -48 L
04 · Fuel sensors · RS232

A fuel probe for exact litres

Not every truck shares its fuel level. A fuel level sensor (LLS) is a probe you fit inside the tank, and it plugs into one of the RS232 ports. It reports the fuel in litres. Fleet Scanner charts each tank and raises an alert when the level falls fast while the truck is parked.

201 LLS 1 fuel level
Fleet fuel management software →
ports · accessoriesDIN1 Ignition ONAIN1 12.4 VDOUT1 Relay OFF
Accessories online
05 · Ports and extras · Wired + Bluetooth

Room for many accessories at once

Teltonika built the FMC650 for trucks that carry a lot of extra kit. It has 2 RS232 ports, 1 RS485 port, 1-Wire for driver keys and temperature probes, and Bluetooth 5.0 for wireless sensors. A USB cable can power it on your desk while you change settings. 16 MB of memory holds about 8 times more records than the older line before a microSD card is needed.

2 x RS232, 1 x RS485 1-Wire Bluetooth 5.0 + LE USB power for setup
Driver management software →
safety · eventsX -612Y 180Z 990
Harsh braking
06 · Driving and safety · Events

Alerts for rough driving, crashes and towing

The FMC650 flags harsh starts, hard braking and sharp turns, plus speeding, crashes and a truck being towed away. Its immobiliser can check a driver key before the engine is allowed to run. Fleet Scanner sends each alert to the right person and adds it to driver scores.

253 Green driving type255 Over speeding247 Crash detection246 Towing251 Immobiliser
Real-time fleet alerts →

FMC650 specifications

StatusCurrent Teltonika model, on sale since 26 January 2023; Teltonika’s named replacement for the FMC640 and FMB641
Network4G LTE Cat 1 with 2G (GSM) backup; two SIM cards or one eSIM; outside antennas
SatellitesGPS, GLONASS, Galileo, BeiDou and QZSS on a separate dual-band (L1 + L5) module, < 2.5 m CEP
Power8 to 32 V DC, overvoltage (Pulse 5a and 5b) and reverse polarity protection; USB power for setup
Backup battery550 mAh Ni-MH, 8.4 V
Inputs and outputs4 digital inputs, 4 digital outputs, 4 analog inputs
Extras2 CAN (J1939) with switchable terminators, J1708, K-Line, 2 x RS232, 1 x RS485, 1-Wire, Bluetooth 5.0 + LE
TachographLive data over K-Line, tacho CAN or FMS; remote DDD file download via TachoSync
Memory16 MB flash plus microSD card up to 32 GB
Working temperature-40 to +85 °C without battery; -20 to +45 °C with the backup battery
Fleet Scanner port11922

Specifications can differ between hardware revisions. Check the manufacturer’s datasheet for your exact unit.

How to connect the FMC650 to Fleet Scanner

  1. Wire the FMC650 to the truck’s power, ground and ignition, then fit the GNSS and mobile antennas. Put in your SIM card, or use the built-in eSIM.
  2. For the FMC650 setup on a desk, plug it into a computer by USB. The cable powers it, so no truck is needed. In the Teltonika Configurator, type your Fleet Scanner server address, port 11922 and TCP.
  3. No computer at hand? Text the tracker. Begin with two spaces, then: setparam 2001:yourAPN;2004:your.server.com;2005:11922;2006:0. Here 2001 holds the SIM’s APN, 2004 your server address and 2005 the port. 2006:0 picks TCP.
  4. Add the unit in Fleet Scanner with its IMEI, link it to a truck and choose FMC650 as the model.
  5. Text getgps to see that it has a fix, then find the truck on the live map. FMS and tachograph data appear once the CAN or K-Line wires are connected.

Teltonika FMC650 FAQ

Is the Teltonika FMC650 still on sale?

Yes. Teltonika started selling it on 26 January 2023. Its own end of life list names the FMC650 as the replacement for the FMC640 and the FMB641, which are both end of life now.

Does the FMC650 support tachograph download?

Yes. Teltonika lists live tachograph data over K-Line, tacho CAN or FMS, and remote download of tachograph (DDD) files through its TachoSync service. For the newest tachographs, Teltonika says the tracker needs firmware 03.00.14.Rev.07 or later.

Which SMS commands work on the FMC650?

getgps sends back the position and time, getinfo gives system details, getparam reads a setting and setparam changes one. Commands are case sensitive. If the tracker is in Deep Sleep, a text will not reach it.

What changed from the FMC640 to the FMC650?

Teltonika says the FMC650 keeps the FMC640’s features and adds a separate dual-band GNSS module, 16 MB of memory, a faster processor, USB power for setup and CAN end resistors you can switch from afar.

How do I connect the FMC650 to a tracking server?

Set the server address, port and TCP in the Teltonika Configurator or with one setparam text. For Fleet Scanner, use your own server’s address and port 11922. Fleet Scanner runs on your server, not someone else’s.

Bring your FMC650 trucks onto one live map.

From a single tracker to a mixed fleet across 1,000+ device models: live tracking, alerts, fuel, drivers, maintenance and reports in one self-hosted platform. See it with your own hardware.

Get a free demo

More supported GPS trackers

AVL IDs from Teltonika’s FMC650 data sending parameters list. Specifications from the Teltonika FMC650 datasheet, product page and launch news. Teltonika and FMC650 are trademarks of Teltonika Telematics.

Take Control with
Fleet Tracking

Track vehicles in real time, optimize routes, and take full control of your fleet operations.

Free Demo