Skip to content
Fleet Scanner
Hardware integration · WanWay EV02

WanWay EV02 GPS tracker for e-bikes and motorbikes, on Fleet Scanner

The WanWay EV02 GPS tracker is a small 2G unit made to stop theft of electric bikes, scooters and motorcycles. It weighs 30 g, takes 9 to 90 V straight from the vehicle battery, and can stop the motor by cutting its speed control line. WanWay lists car anti-theft as a use too. Point it at Fleet Scanner, installed on hardware you control, and every two-wheeler in your fleet shows on one live map with its alarms and past rides.

2G GSM quad-band9 to 90 V battery inputSpeed line motor cut-offPort 10214
WanWay EV02 GPS tracker, a small black rounded box with three status lights on its face and a black 4-pin connector on a flat lead
30 gdevice weight
72 x 31 x 12 mmcase size
10 sbetween GPRS uploads
55 mAhbuilt-in battery
IPX5waterproof level
gprs · every 10 s
GPRS onlineUpload 10 s
01 · Ride tracking · GPS + GPRS

EV02 GPS tracker positions every 10 seconds

Out of the box the EV02 keeps a constant GPRS link and reports where it is once every 10 seconds. The spec sheet puts its GPS accuracy at about 5 metres. Under open sky it needs less than 2 seconds from a hot start and less than 38 seconds from cold. Fleet Scanner stores all of these points. Later you can replay a rider’s route and check how many kilometres each scooter did that week.

Upload every 10 s Always online Trace playback Mileage report
Live GPS tracking →
output · speed line
Motor STOPPEDRelay on
02 · Motor cut-off · Yellow wire + relay

Stop an e-bike motor by cutting its speed control line

On an electric bike, the EV02 does its stop engine job through a relay on the yellow wire. The manual tells the fitter to find the speed control line that runs to the controller, check its voltage with a meter, and cut it in two. Each cut end then goes to one of the relay’s two green lines. WanWay says the cut can be sent by SMS, from its app or from a platform. Fleet Scanner hides that button from anyone you have not given the right to use it.

Yellow: relay Speed control line Relay 85 / 86 Relay 87 / 87A
Theft protection for assets →
sensor · vibrationsleepmoving
MovedParked yes
03 · Vibration and moving · Accelerate sensor

Alarms when a parked scooter is shaken or moved

The EV02 has an acceleration sensor inside. It sends a vibration alarm when someone shakes or knocks the parked bike, and a displacement alarm when the bike is moved away. The spec sheet also lists a collide alert. Fleet Scanner pushes each alarm to the right phone and puts a pin where the bike was.

Vibration alarm Displacement alarm Collide alert Accelerate sensor
Fleet alerts management software →
alarm · cut wire12.6V
Battery wire cutACC OFF
04 · Battery and key · Red, black and orange wires

Cut-wire alarm and ACC detection on a 4 pin plug

Red goes to the plus pole of the battery and black to the minus pole. Orange joins the key switch line, so the EV02 notices every time the ignition (ACC) changes. If a thief cuts the main power, the tracker sends a cut-wire alarm. It then runs on its 55 mAh battery inside, and a low battery alarm follows when that runs down. Fleet Scanner uses the key changes to split rides into trips.

ACC detection Cut-wire alarm Low battery alarm 55 mAh battery
Trip records →
alarm · zone / speed
Zone outsideSpeed 45 km/h
05 · Zones and speed · Geo-fence + over-speed

Geo-fence and over-speed alarms for riders

WanWay lets you draw a zone as a circle, a polygon or your own shape. Each time the EV02 crosses that edge, WanWay sends an alarm to the app or by SMS. Pick a speed limit as well, and the tracker warns you each time a rider goes over it. Fleet Scanner adds its own zones, for example one for a rental shop and one for the delivery area, each with its own alert list.

Circle zone Polygon zone Zone in / out Over-speed alarm
Geofence alerts →
leds · red / yellow / blueDIN1 Ignition ONAIN1 12.4 VDOUT1 Relay OFF
GSM slow blinkGPS slow blink
06 · Status lights · Three LEDs

Three lights that show what the EV02 is doing

Red is power. It stays on when the tracker runs on the vehicle battery and blinks slowly when it runs on its own battery. Yellow is GSM and blue is GPS. Both blink fast while they search and slowly when they work. If either one is off, it could not find a signal or it is sleeping. A fitter can read all of this at a glance before closing the cover.

Red: power Yellow: GSM Blue: GPS
Fleet reports and dashboards →
checks · web / app / smsX -612Y 180Z 990
Firmware OTASetting SMS
07 · Remote checks · SMS, platform, OTA

Change settings by SMS and update it over the air

Settings on the EV02 are changed with text messages or through a tracking platform, and its status can be checked on the web, in an app or by text. Firmware updates go over the air, so nobody has to take the tracker off the bike. With Fleet Scanner, your team checks the same bikes from a browser or a phone app, and a built-in AI agent can answer questions about the fleet.

SMS setting Platform setting Web / app check OTA upgrade
Fleet reports software →

EV02 specifications

Network2G GSM 850/900/1800/1900 MHz, GPRS class 12, TCP/IP, built-in GSM module
PositioningGPS, 32 channels, about 5 m accuracy
Time to first fixHot under 2 s and cold under 38 s (open sky), warm under 15 s
Tracking sensitivity-160 dBm
AntennasBuilt in: spring antenna for GSM, 18 x 18 x 4 mm ceramic chip antenna for GPS
Input voltage9 to 90 V DC
Backup battery55 mAh, built in
Wires4 pin plug: red plus, black minus, orange ACC, yellow relay
Sensors and buttonsAcceleration sensor, ACC detection, power button; no SOS button, no microphone
LightsRed power, yellow GSM, blue GPS
Upload intervalEvery 10 seconds, always online
SettingsSMS command or platform; web and app checks; OTA upgrade
Size / weight72 x 31 x 12 mm, 30 g
EnvironmentIPX5, -20 to 70 °C
ProtocolGT06 family (Traccar lists the WanwayTech EV02 under gt06)
Fleet Scanner port10214 (TCP)

Specifications can differ between hardware revisions. Check the manufacturer’s datasheet for your exact unit.

How to connect the EV02 to Fleet Scanner

  1. Buy a 2G SIM card. The EV02 manual says it needs GPRS data, SMS and phone calls. Lift the SIM cover, slide the card in, and switch on the small battery switch inside.
  2. Ask someone who has fitted GPS trackers before to install it. Choose a hidden, dry place where nothing metal covers the case and the lights face the front. Fix it in place with cable ties or tape so it cannot rattle loose.
  3. Plug in the 4 pin cable: red to the battery plus pole, black to the minus pole, orange to the key switch (ACC). To use the cut-off, cut the speed control line and put the relay’s two green lines on the cut ends. WanWay says a car needs a 12 V relay and a truck a 24 V relay.
  4. Tell the EV02 to report to Fleet Scanner: give it your server’s domain or IP, port 10214, and the APN of your SIM company. WanWay lists two ways to do it: a text message command or a platform. The manual does not print the commands, so get the exact wording from WanWay for your firmware.
  5. Add a new device in Fleet Scanner and enter the 15 digit IMEI shown on the tracker’s rear label. Once the yellow and blue lights blink slowly, ride around the block and make sure the route appears on the map.

WanWay EV02 FAQ

Does the WanWay EV02 work with Fleet Scanner?

Yes. Once the EV02 reports to port 10214 on the server where you run Fleet Scanner, you see its live place, key state, trips and alarms in one view. The motor cut-off button shows only for the users you allow, and white label is included.

What are the EV02 SMS commands?

The EV02 spec sheet says settings go in by SMS or platform, yet neither the manual nor the spec sheet spells out a single command. Before you move the tracker to your own server, ask WanWay to send the APN and server commands that match your firmware.

How does the EV02 stop an electric bike?

It uses a relay on its yellow wire. The fitter cuts the speed control line that runs to the motor controller and joins the two ends to the relay. When you send the cut-off, the relay breaks that line, so nobody can ride the bike away.

How long does the EV02 run without the vehicle battery?

No run time is printed in the EV02 papers from WanWay. They list a 55 mAh battery inside, which takes over if the main power is lost, and a low battery alarm for when it runs down. The red light blinks slowly while the tracker runs on that battery.

Why is my EV02 not online or not showing a location?

The manual lists the usual causes. Check that the SIM is in and seated well, and that it has GPRS switched on. Move to a place with a strong GSM signal. In a basement or tunnel there is no GPS, so take the bike out under open sky.

Is the WanWay EV02 still made, and is there a 4G version?

WanWay still has the EV02 on its vehicle tracker page at wanwaytech.net, with the flyer, manual and spec sheet to download. It only uses 2G, so it stays offline in any country that has shut its 2G network. WanWay does not name a 4G version of the EV02, so check your local network first.

EV02 fitted. Every e-bike and scooter tracked from your own server.

From a single tracker to a mixed fleet across 1,000+ device models: live tracking, alerts, fuel, drivers, maintenance and reports in one self-hosted platform. See it with your own hardware.

Get a free demo

More supported GPS trackers

Specs, wiring, lights and functions come from the EV02 product page, EV02 flyer, EV02 technical specification and EV02 user manual on wanwaytech.net. The GT06 protocol family is taken from Traccar’s device list, which names the WanwayTech EV02. WanWay and EV02 are trademarks of Shanghai WanWay Digital Technology.

Take Control with
Fleet Tracking

Track vehicles in real time, optimize routes, and take full control of your fleet operations.

Free Demo