Skip to content
Fleet Scanner
Hardware integration · Jimi IoT JM-LG05

Jimi IoT JM-LG05 package GPS tracker, working inside Fleet Scanner

The Jimi IoT JM-LG05 is a flat GPS tracker that you put inside a box, crate or parcel. It is made by Jimi IoT (Concox) for shipping and logistics. The body is only 8 mm thick and weighs 76 g, so it slips in with the goods. A light sensor tells you when someone opens the package. It runs on a 2,500 mAh battery and uses the 2G mobile network. Fleet Scanner reads its positions, battery level and alerts, so every shipment shows up on your map.

8 mm ultra-thin body2,500 mAh internal batteryGSM 2G quad-bandPort 10013
Illustration of the Jimi IoT JM-LG05 GPS tracker
8 mmthin enough for a parcel
76 gtotal weight
2,500 mAhrechargeable battery
1 yearstandby in power-saving mode
< 2.5 mGPS accuracy (CEP)
location · mode 1
Parcel in transitGSM
01 · Tracking mode · Mode 1

Follow a shipment while it is on the road

In tracking mode, the JM-LG05 keeps sending its position while the goods travel. Fleet Scanner puts each package on the live map next to the truck or van that carries it. It saves the full route, so you can play back where a box went and when it got there.

0x01 Login Location packet Speed Time
Live vehicle tracking →
standby · mode 268%
Mode SAVINGBattery 92 %
02 · Power-saving mode · Mode 2

Up to a year of standby for long trips

Some goods sit in a port or warehouse for weeks. For those, switch the JM-LG05 to power-saving mode. It spends most of its time asleep and checks in less often. Jimi IoT rates it at up to 1 year of standby in this mode. Real life depends on how often it reports and on the signal.

Power-saving mode Battery level
Fleet asset management software →
alarm · light sensorX -612Y 180Z 990
Box openedLight detected
03 · Unpacking alert · Light sensor

Know the moment a box is opened

Inside a closed box it is dark. When someone opens the package, light hits the sensor in the JM-LG05 and it sends an unpacking alert. Fleet Scanner passes the alert on straight away and marks the spot on the map. You can see if a shipment was opened before it reached the customer.

Unpacking alert Light sensor
Fleet alerts management software →
lbs · cell towers
Fix LBSTowers 2
04 · Cell tower location · GPS + LBS

A rough place even when GPS is blocked

Packed inside a container or stacked in a warehouse, the tracker may not see the sky. Then it can use the mobile towers around it. This is called LBS, which means location from cell towers. Fleet Scanner shows the area the parcel is in, and moves back to an exact GPS point when one comes in.

MCC MNC LAC Cell ID
geofence · in / out
Zone Port gateLeft zone
05 · Geofences · Alarms

An alert when cargo goes in or out of a zone

A geofence is a zone you draw on the map. The JM-LG05 sends a geo-fence alert when it goes in or out of one. Fleet Scanner lets you add as many zones as you need around depots, ports and delivery sites. A parcel that leaves the planned area gets noticed fast.

Geo-fence in Geo-fence out
Fleet geofencing software →
status · 0x1312.6V
Battery 18 %Signal 3/5
06 · Battery status · Status packet

Low battery alerts before a tracker goes quiet

The JM-LG05 sends a low battery alert when its charge drops. Fleet Scanner shows the battery level of every tracker in one list. You can pull the ones that need charging when the parcel is unpacked, top them up and send them out with the next load.

0x13 Status / heartbeat Low battery alert Battery level
Fleet reports and dashboards →

JM-LG05 specifications

NetworkGSM (2G) quad-band 850/900/1800/1900 MHz
PositioningGPS + LBS, < 2.5 m CEP
Time to first fixHot start about 1 s, cold start about 45 s
Battery2,500 mAh / 3.7 V industrial-grade Li-Polymer, rechargeable (charger 5 V / 1 A)
Working modesTracking mode and power-saving mode; up to 1 year standby in power-saving mode
InterfacesNano-SIM, 1 green power light, 1 red/blue status light, 32+32 Mb storage
SensorsAccelerometer, light sensor for unpacking alerts
Size / weight110 x 61 x 8 mm, 76 g
Operating range-20 to +70 °C, 5% to 95% humidity (non-condensing)
ProtocolGT06 family (Jimi IoT), over TCP
Fleet Scanner port10013 (TCP)

Specifications can differ between hardware revisions. Check the manufacturer’s datasheet for your exact unit.

How to connect the JM-LG05 to Fleet Scanner

  1. Charge the JM-LG05 with the charger and USB cable from the box. Put in a Nano-SIM card that has 2G (GSM) data service where the goods will travel.
  2. Send the SMS commands from the Jimi IoT manual to the tracker’s SIM number. Set the APN (the SIM’s internet settings) and point it at your Fleet Scanner server’s domain or IP with port 10013. Pick tracking mode for short trips or power-saving mode for long ones.
  3. In Fleet Scanner, add the tracker by its IMEI number and link it to the shipment, pallet or customer order.
  4. Lay the JM-LG05 flat inside the box with the goods, then close and seal it. Check the first position on the map before the package leaves.

Jimi IoT JM-LG05 FAQ

Can I use the Jimi IoT JM-LG05 with Fleet Scanner?

Yes. The JM-LG05 talks in the GT06 family protocol that Fleet Scanner reads on port 10013. You get its positions, battery level and its unpacking, geo-fence and low battery alerts. Since Fleet Scanner runs on your own server, the shipment data stays with you.

How does the JM-LG05 know a package was opened?

It has a light sensor. A sealed box is dark inside. When the box is opened and light gets in, the tracker sends an unpacking alert. Fleet Scanner shows the alert with the time and the place it happened.

How long does the JM-LG05 battery last on one charge?

It has a 2,500 mAh battery. Jimi IoT says it lasts up to 1 year in power-saving mode. Tracking mode reports more often, so it uses the battery faster. Fleet Scanner warns you when the level gets low.

Does the JM-LG05 work on 4G?

No. It uses GSM, the 2G network, on four bands (850, 900, 1800 and 1900 MHz). Before you ship with it, check that 2G is still running in the countries on the route. Some networks are switching 2G off.

JM-LG05 in the box. Every shipment on your map.

From a single tracker to a mixed fleet across 1,000+ device models: live tracking, alerts, fuel, drivers, maintenance and reports in one self-hosted platform. See it with your own hardware.

Get a free demo

More supported GPS trackers

Packet types follow the GT06-family protocol used by Jimi IoT trackers. Battery figures are Jimi IoT’s ratings and depend on settings and signal. Jimi IoT, Concox and JM-LG05 are trademarks of Jimi IoT. Specifications from the Jimi IoT JM-LG05 product pages.

Take Control with
Fleet Tracking

Track vehicles in real time, optimize routes, and take full control of your fleet operations.

Free Demo